Cisco Discovery Protocol
Cisco Discovery Protocol (CDP) allows ESX administrators to determine which Cisco switch port is connected to a given vSwitch. When CDP is enabled for a particular vSwitch, you can view properties of the Cisco switch (such as device ID, software version, and timeout) from the vSphere Client.
Enable CDP on an ESX Host
vSwitches are set to detect Cisco port information by default. You can also set the CDP mode so that a vSwitch makes information available to the Cisco switch administrator.
1
|
Log in directly to your ESX host’s console. | ||||||||||
2
|
View the current CDP mode for the a vSwitch by entering the esxcfg-vswitch -b <vSwitch> command. If CDP is disabled, the mode will be shown as down. |
||||||||||
3
|
Change the CDP mode by entering the esxcfg-vswitch -B <mode> <vSwitch> command.
|
When CDP is set to listen or both, you can view Cisco switch information.
Procedure
1 |
Log in to the vSphere Client and select the host from the inventory panel. |
2 |
Click the Configuration tab and click Networking. |
3 |
Click the info icon to the right of the vSwitch. |